Formatting The Extended Partition - Epson 20 User Manual

Epson equity 386/20 - user manual
Hide thumbs Also See for 20:
Table of Contents

Advertisement

Formatting the Extended Partition

Once you have formatted the primary partition and copied the
remaining MS-DOS files to the hard disk, follow this procedure to
format the extended partition:
1.
Insert the working copy of your MS-DOS Startup diskette in
drive A (if it is not there already).
2.
At the
prompt, type the following and press
A>
FORMAT D:/V
3.
The screen displays this message and prompt:
WARNING, ALL DATA ON NON-REMOVABLE DISK
DRIVE D: WILL BE LOST!
Proceed with Format (Y/N)?
4.
Press Y and
The screen continuously displays the changing head and cylinder
numbers. When the procedure is complete, the screen displays
the following message:
Format complete
Volume label (11 characters, ENTER for none)
5.
It is a good idea to enter a name (volume label) for drive D, to
protect it from being accidentally reformatted later. If you want to
name this drive, type up to 11 characters and press
do not want to name it, just press
The screen displays information about the total disk space
available on drive D. The A > prompt reappears.
6.
If you have created additional logical drives on your hard disk,
repeat steps 1 through 5 above for each additional logical drive.
Substitute the appropriate drive letter in the FORMAT
command. For example, to format drive E, type the following and
press
Enter:
FORMAT E: /V
3-12
Preparing a Hard
to begin formatting the extended partition.
Enter
for
Disk
Use
Enter:
Enter.
you
Enter. If

Advertisement

Table of Contents
loading

This manual is also suitable for:

386Equity 386/20

Table of Contents