Assembly And Adjustments; Attaching Side Handle; Rotating The Gear Case; Accessories - DeWalt D28402 Instruction Manual

FIG. 1
C
D28402
D28402N
F
I
D28110
D28112
S
A
K
B
J
(D28402)
L
L K
G
H
K

ASSEMBLY AND ADJUSTMENTS

ATTACHING SIDE HANDLE

The side handle (E) can be fitted to either
side of the gear case in the threaded holes,
as shown. Before using the tool, check that
the handle is tightened securely. Use a
wrench to firmly tighten the side handle.

Rotating the Gear Case

Turn off and unplug tool before making
any adjustments or removing or installing
accessories. Before reconnecting the tool,
depress and release the trigger switch
to ensure that the tool is off.
1. Remove guard and flanges from tool.
2. Remove the four corner screws
attaching the gear case to motor
housing.
3. Separating the gear case from motor
housing not more than 1/4", rotate the
gear case head to desired position.
NOTE: If the gear case and motor housing become separated by
more than 1/4", the tool must be serviced and re-assembled by a
D WALT service center. Failure to have the tool serviced may
E
cause brush, motor and bearing failure.
3. Re-install screws to attach the gear case to the motor housing.
Tighten screws to 18 in./lbs. torque. Overtightening could cause
screws to strip.

Accessories

It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See pages 6–7 for infor-
mation on choosing the correct accessories.
5
E
90˚
90˚