Rear
Front
hole
Place the output tray in front of you and insert each of the
two wire paper holders into the holes at the edge of the
output tray, as shown below.
To attach
output tray to
the
holes on either side of the output tray base. Then
pegs on
side of the output tray into these holes, as
either
shown below.
Note
This tray can used in a horizontal position instead of
the vertical position shown on the next page. If you plan to
use the tray in the horizontal position, insert the pegs into
the rear slots instead of
output tray as far back as it will go.
Set t ing Up t h e Priorit yFax
output tray base, locate the
the
front holes. Then push the
the
insert the
1-7