Advertisement
Remove w and extension.
Press theMaster ON/OFF s witch totheONposition.
_L
CAUTION:
You must be careful at this point.
Anytime you squeeze the trigger, the motor
will start and water will spray out of the gun.
Turn ON water. Water supply should not exceed
104°F. Use a cold water source.
Squeeze trigger on spray gun. Motor will start and
force air from high pressure hose.
Adjust the Safety Latch on spray gun to ON position.
This disables the trigger so you cannot inadvertantly
actuate a spray stream.
Reconnect the wand extension.
Adjust nozzle for correct pressure, spray angle.
Place Safety Latch in OFF position and squeeze trig-
ger on spray gun. Motor will start and water should
stream from the nozzle.
IMPORTANT: The pump will NOT run without the water
supply connected and turned ON.
SIPHONING
We recommend that you DO NOT siphon your water sup-
ply. Connect only to household water supply.
TIPS
Never leave the pressure washer unattended while it
is plugged into an electrical outlet and while water is
supplied to the machine.
Never use the garden hose inlet to siphon detergent
or wax.
If you have the spray nozzle too far away, the clean-
ing will not be as effective.
GENERAL
RECOMMENDATIONS
The warranty of the high pressure washer does not cover
items that have been subjected to operator abuse or neg-
ligence. To receive full value from the warranty, operator
must maintain high pressure washer as instructed in this
manual.
BEFORE EACH USE
A
DANGER:
Water spraying from a leak
is capable of injecting material into skin.
NEVER repair a high pressure hose.
Replace a bad hose with a hose that
meets the minimum pressure rating of
your pressure washer.
Check and Clean Quick-connect Screen: Remove
quick-connect and examine inlet screen on the female
connector. Clean if it is clogged or replace if it is torn.
Check High Pressure Hose: High pressure hose can
develop leaks from wear, kinking, abuse. Inspect hose
each time before using it. Check for cuts, leaks, abrasions
or bulging of cover, or damage or movement of couplings.
It any of these conditions exist, replace hose immediately.
Check Detergent Hose: Examine the filter on the deter-
gent hose and clean if clogged. Hose should fit tightly on
barbed fitting. Examine hose for leaks or tears. Replace
the filter or hose if either is damaged.
Check Gun and Wand: Examine hose connection to gun
and make sure it is secure. Test trigger by pressing it and
making sure it springs back into place when you release
it. Put safety latch in ON position and test trigger. You
should not be able to press trigger.
PRODUCT SPECIFICATIONS
PRESSURE
FLOW RATE
9ETERGENT MIX
WATER SUPPLY
TEMPERATURE
MOTOR
RATED VOLTAGE
CURRENT
1250 osi
!,5 GPM
Use undiluteddeterqent
Not te exceed 104°F
Brush Type
120 volts
13.5 amps
8
Advertisement
