Problems Printing
Cannot configure for USB connection.
Windows NT 4.0 does not support USB. Windows 98
upgraded from Windows 95 may not support USB.
Possible cause
USB cable does not meet
specifications.
Interface is disabled.
Configuration procedure
was not correctly
followed or cancelled.
USB cable is
disconnected or faulty.
A USB hub is being used. The printer cannot be used with a USB hub.
The USB cable is
installed in the Ethernet
port.
NOTE
Remedy
Use USB cable to specification Ver.1.1.
Check that USB interface is set to Enable in the
menu (
USB MENU
Configure again from the beginning.
Reconnect or try another cable.
Connect the printer and computer directly.
Make sure the USB cable is plugged into the
black USB port (
Troubleshooting • 102
→
→
USB
ENABLE
1
) on the printer:
).