Flash; Self Timer - Epson PhotoPC 700 User Manual

Note:
If you select one of the monochrome image quality settings
when the LCD monitor is in View mode, the image turns from
color to black and white, a blue frame appears around the
image, and MONOCHROME appears briefly on the screen.
You can switch freely between these settings and mix
pictures of varying quality in the camera. The camera's
image capacity will vary accordingly.

Flash

The PhotoPC 700's built-in flash is effective
within a range of 20 cm to 2.4 m. Press the flash
control button to cycle through the three flash
settings. The settings appear on the display panel as
shown below.
Automatic (default setting)
Forced flash
Flash off
Automatic
The flash fires automatically whenever more
lighting is needed.
Forced flash
The flash fires with every picture you take. Use
this setting to compensate for backlighting; for
example, when you are facing the sun.
Flash off
The flash is disabled, even when adequate
lighting is not available. Use this setting for
special effects, or when flash photography is
prohibited.
Note:
After taking a flash photo, the flash icon blinks until the flash is
fully recharged.

Self timer

Setting the self timer creates a 10-second delay
between the time you press the shutter button
and the actual image capture. This allows you
to take a picture of yourself. The timer icon appears on
the display panel when you use the timer. Follow these
steps to take a picture with the timer:
Taking Pictures with PhotoPC 700
2
2-9