Table of Contents
Advertisement
\
Engine
Guards
FIGURE 30.
6. Separate
the snow thrower into two halves as
follows.
a. Using a 9/16" wrench, remove the top bolts
which attach the auger housing to the frame
assembly. Loosen (do not remove) the bottom
bolts. See figure 31.
b. Lift up on the auger drive belt to pull the auger
housing off the frame assembly. The snow
thrower will separate into two halves.
c. Tip the auger housing forward so it rests on the
front of the housing.
_NOTE
Be certain
to check
the condition
of
the drive belt when the two halves of
the
unit
are
separated.
Replace
if
necessary.
Auger
.*It
7. Using e 15116" wrench, remove the four shoulder
bolts and cupped
washers
which
act as belt
keepers. See figure 32.
8. Roll belt off the auger pulley.
9. Reassemble
new belt in reverse order.
I
i
FIGURE 32.
Drive Belt
1. Follow steps 1 through 6 of the previous section.
2. Disconnect the extension spring at the engine
plate. See figure 33.
3. Remove the drive belt from the engine pulley and
bottom drive pulley. See figure 33.
Drive
Engine
Bottom
Drive
Pulley
FIGURE 31.
(Do Not Remove)
Remove
Bolt
[
FIGURE 33.
4. Replace belt. Reassemble
snow thrower, follow-
ing instructions
in reverse order.
W
NOTE
Be certain the auger arm assembly pin is
in the slot of auger clutch bracket before
inserting top bolts into auger housing
and frame. See figure 34.
17
Hide quick links:
Advertisement
Table of Contents
