Advertisement
Available languages
Available languages
SERVICE
RECORDS
Fill In dates as
you complete
regular service
TighienAll Screws & Nuts
Check Spark Plug
1
check Drive Belts
LUbricate ChuteControtRange
,,,,,L
Check Fuel
,,,,. .....
,,Jr
,,,,
Drain Fue!
Before
Each
Use
After
first 12
Hours
SCHEDULE
As
Before
Needed
Storage
v"
v"
Begin
Each
Season
SERVICE
DATES
GENERAL RECOMMENDATIONS
The warranty
on this snow thrower
does not
cover items that have been subjected
to op-
erator abuse
or negligence.
To receive full
value from the warranty,
the operator
must
maintain
the snow thrower
as instructed
in
this manual.
The above chart is provided
to
assist the operator
in properly
maintaining
the snow thrower.
LU BRICATION
CHART
SNOW
THROWER
AFTER
FIRST
USE
o Check for any loose or damaged parts
after each use.
• Tighten any loose fasteners.
AFTER
EACH
USE
, Run the machine to clear the auger of
snow.
• Remove all snow and slush from the snow
thrower to prevent freezing of auger or
controls.
LUBRICATION
- AS REQUIRED
. Lubricate the flange on the discharge
chute before storage, See To Remove
Top Cover instructionson page 12_
° See Lubrication Chart diagram for
lubrication points and type of lubricant.
1t
Lubricate chute controt flange,
Coatflange with aclingingtype
grease such as Lubriplate,,
ENGINE
SPARK
PLUG
• Clean the spark plug and reset the gap
periodically. To service or replace spark
plug, see To Replace the Spark Plug
paragraph on page 15.
• Make sure that the spark plug is tightened
securely into the engine and the spark
plug wire is attached to the spark plug.
• If a torque wrench is available, torque
plug to 18 to 23 foot pounds.
• Clean the area around the spark plug
base before removal to prevent dirt from
entering the engine.
Advertisement
