Install Discahrge Chute / Chute Rotater Head; Install Chute Deflector Remote Control; Check Tire Pressure - Sears Craftsman 944.527700 Owner's Manual

AS BLY / RE-O ERATION
iNSTALL DISCHARGE CHUTE / CHUTE ROTATER
HEAD (See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may
be used to install the chute rotater head,
1, Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower,
2, Position chute rotater head overchute bracket, If neces-
sary, rotate chute assembly to align square and pin on un-
derside of chute rotater head with holes in chute bracket,
3, With chute rotater head and chute bracket aligned,
position chute rotater head on pin and threaded stud
of mounting bracket,
4, Install 3/8 washer and Iocknut on threaded stud and
tighten securely,
PIN
STUD
CHUTE
ROTATER
ROTATER HEAD
MOUNTING
BRACKET
FIG. 7
iNSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 8 and 9)
1, Install remote cable bracket to discharge chute with
5/16-18 carriage bolt and 5/16-18 Iocknut as shown,
Tighten securely,
2, Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon washer and 1/4-20 Iocknut
as shown, Tighten securely,
3, Install spring hooks between hex nuts on chute rotater
head and into hole in chute deflector as shown,
SPRING
1/4-20 CHUTE
SHOULDER
HOOK
NYLON BETWEEN
WASHER HEX NUTS
ON CHUTE
1/4-20 ROTATER
LOCKNUT
CABLE
EYELET
5/16- ! 8
CARRIAGE
BOLT
_B _EMOTE
CABLE
RACKET
5/16-18
LOCKNUT
FiG. 8
CHUTE DEFLECTOR
CONTROL LEVER
// //
FIG. 9
CHECK TiRE PRESSURE
The tires on you r snow th rower were overinflated at the fac-
tory for shipping purposes. Correct and equal tire pressure
is important for best snow throwing performance,
• Reduce tire pressure to 14-17 PSi (19-24,5 N-m),