Sears Craftsman 944.527700 Owner's Manual page 10

O ERATION
GASOLINE ELECTRIC AUGER DISCHARGE CHUTE CONTROL LEVER
START BUTTON CONTROL
LEVER DRIVE SPEED DEFLECTOR REMOTE
RECOIL X CONTROL LEVER CONTROL LEVER
\
STARTER
HANDLE
' TRACTION
CHUTE DRIVE
CHOKE DEFLECTOR CONTROL
CON- LEVER
TROL
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
CHUTE
_HTURN
TRIGGER
LIGHT
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
\
CLEAN-OUT TOOL i
HANDLE
KNOB
TOOLBOX
CONTROL
DRIFT CUTTER
PLATE
FIG. 10
MEETS A,N,S,I, SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute,
Toolbox = used to store spare shear bolts, Iocknuts and
wrench,
Safety ignition key - must be inserted for the engine to
start and run, Remove when snow thrower is not in use,
Electric start button - used for starting the engine,
Recoil (auxiliary) starter handle- used for starting engine,
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine,
Choke Control - used for starting a cold engine,
ON / OFF switch =used to STOP the engine,
Freewheel control - disengages transmission for pushing
the snowthrower with the engine off,
10
LH and RH turn triggers - used to steer the snow thrower,
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower,
Traction drive control lever- used to engage power-pro-
pelled forward or reverse motion of snow thrower,
Auger control lever - used to engage auger motion
(throw snow),
Discharge chute control lever - used to change the
direction the snow is thrown,
Deflector remote control lever - used to change the
distance the snow is thrown,
Skid plate - used to adjust height of scraper barfrom ground,
Drift cutter - used to cut through deep snowdrifts,