Jointer To Stand Assembly - Craftsman 152.217060 Owner's Manual

10.Position theswitch(S)through thebackside ofthe
frontpanel. M akecertain thatthe"START" buttonis
positioned t othetop.Attach the switch tothefront
panel w iththefourscrews. S eeFigure10.
#10-24 x 3/8"Phillips Head Flange Screw(qty.4)
JOINTER TO STAND ASSEMBLY
,
Position the Jointer/Planer (A) onto the stand (B) so
that the outfeed table (C) is to the same side as the
dust chute (D). See Figure 11.
Jointer/Planer
R
S
Figure 10
T
U
Figure 11 A
C
F
E
D
H
G
B
11.
12.
Assemble the right side panel (T) to the stand.
There is a group of three holes in the right side
panel. These three holes are used to attach the
push block holder (U) to the right side panel in a
later step. Make certain the two holes that are in line
of each other are positioned to the top. The single
hole is toward the bottom of the stand. See Figure 10.
Right Side Panel
#10-24 x 3/8" Phillips Head Flange Screw (qty. 12)
Align the three mounting holes (not shown) in the
push block holder with the three holes in the right
side panel, and attach using three screws provided.
Push Block Holder
#10-24 x 3/8" Phillips Head Flange Screw (qty. 12)
11
,
Align the three threaded holes in the bottom of the
jointer to the three holes in top of the stand. Fasten
the jointer to the stand with the three lock-washers
and special bolts provided. The two right side holes
can be accessed through the rear of the enclosed
stand. The single hole on the left side can be
accessed through the left side panel's dust chute
opening.
Special Bolt (qty. 3)
M10 Lock Washer (qty. 3)
,
Remove screw and washer from end of outfeed
table raise/lower shaft (E). Assemble hand wheel
(F) onto shaft and re-assemble washer and screw.
See Figure 11.
Hand Wheel
,
Thread infeed table raise/lower handle (G) with nut
into threaded block underneath infeed table (H).
Tighten nut on handle against threaded block to lock
handle into position. See Figure 11.
Infeed Table Handle