Download Print this page

Craftsman 536.881410 Operator's Manual page 25

650 series, 4-cycle engine 21-inch single stage auger propelled

Advertisement

Available languages

Available languages

TROUBLE
CORRECTION
Difficult
starting
Replace spark plug.
CAUSE
Defective spark plug.
Water or dirt in fuel system.
Drain and clean the fuel tank.
Refill with fresh fuel.
Engine runs erratically
Blocked fuel line, empty gas
Clean fuel line; check fuel
tank, or stale gasoline,
supply; add fresh gasoline
Engine stalls
Unit running on CHOKE.
Set choke lever to run or off
position.
Engine runs erratically;
Water or dirt in fuel system.
Drain and clean the fuel tank.
Loss of power
Refill with fresh fuel.
Excessive
vibration
Damaged auger assembly
Unit fails to propel itself
Loose parts. Damaged
impeller.
Drive belt loose or damaged.
Incorrect adjustment of auger
drive cable
Auger drive belt loose or
damaged.
Auger control cable not
adjusted correctly.
Discharge chute clogged.
Foreign object lodged in
auger
Unit fails to discharge
snow
Repair or replace the auger
assembly.
Immediately stop engine.
Remove ignition key. Tighten
all fasteners and make all
necessary repairs.
If
vibration continues, take the
unit to a Sears service
center.
Replace drive belt.
Adjust auger drive cable.
Adjust auger drive belt;
replace if damaged.
Adjust auger control cable.
Stop engine immediately
and
disconnect spark plug wire.
Clean discharge chute and
inside of auger housing.
Stop engine immediately
and
disconnect spark plug wire.
Remove object from auger.
1741476
25

Advertisement

loading