Unpack Thepressure W Asher; Attach Handle And Accessory Tray; Carton Contents - Craftsman 580.752193 Operator's Manual

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1-800-222-3136.
UNPACK THEPRESSURE W ASHER
1. Remove everything from carton except pressure washer,
2. Open carton completely by cutting each corner from top
to bottom.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach spray tip extension to spray gun.
9. Select/attach quick connect spray tip to spray tip
extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
3. Remove pressure washer from carton.
CARTONCONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
* Main Unit
* Handle
* Accessory Tray
* High Pressure Hose
* Spray Gun
* Spray Tip Extension with Quick Connect Fitting
* Oil Bottle
* Hose Wrap
* DetergentSiphoning Hose/Filter
* Bottle Bracket Wireform
* PerfectMix
TM
Siphoning Unit/Hose
* Parts Bag (which includes the following):
* Operator's Manual
* Owner's Registration Card
* Bag containing 4 multi-colored Spray Tips
* HandleFasteningHardwareKit (which includes):
* Handle Bolts (2)
* Carriage Bolt (1)
* Plastic Knobs for Handle (2)
* Rope Guide (1)
* Plastic Knob (2)
* Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
.
insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit. Tighten by hand. By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store fiat atop the cold engine.
NOTICE DONOT fold the handle down while the engine is
hot.
3. Placeaccessory tray (F) over holes (G) on handle
(viewing from back of unit). Push the tree clips (H) into
the holes until they sit fiat against the accessory tray.
,
/
insert multi-colored Quick Connect spray tips and other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.