Craftsman 580.752193 Operator's Manual page 13

NOTICE Spray gun traps high water pressure, even when
engine is stopped and water is disconnected.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, spray tip extension and quick connect
spray tips. There is also a detachable hose wrap at the back
of the accessory tray to hold your high pressure hose.
1. Place spray tip extension in clip on back of accessory
tray.
2. Place spray gun through hole on accessory tray on right
side of unit.
3. insert multi-colored spray tips in spaces provided in
accessory tray.
4. Wrap high pressure hose on hose wrap then attach hose
wrap to back of accessory tray.
5. Hook provided on back of accessory tray for safely
storing safety goggles.
How to Use Spray Tips
The quick-connect on the spray tip extension allows you to
switch between four different quick connect spray tips. The
spray tips vary the spray pattern as shown below.
Low Pressure
Black
Use to apply
chemical
40° White
1750 PSi
2.3 GPM
High Pressure
m i
15° Yellow
2200 PSi
2.2 GPM
F-----q
0° Red
2550 PSi
2.0 GPM
Foflow these instructionsto chanoespray tips:
1. Pull back collar on quick-connect and pull current spray
tip off. Store spray tips in holder provided on the
accessory tray.
A WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVER exchange spraytips withoutthetriggerlockedon the
spraygun.
• DONOT twist spraytips whilespraying.
2. Select desired spray tip:
• For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select white 40°
spray tip.
• For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select yellow
15° spray tip.
• For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
• To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
3. Pull back on collar, insert new spray tip and releasecollar.
Tug on spray tip to make sure it is securelyin place.
Usage Tips
* For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
* If you get spray tip too close, especially using a high
pressure spray tip, you may damagesurface being
cleaned.
* DONOT get closer than 6 inches (15 cm) when cleaning
tires.
2-1N-1 Soap System
A WARNING ChemicalBurn Hazard.
_ hemicals could cause bodily injury, property damage or death.
• DONOT usecausticliquidwith pressure washer.
• UseONLYpressure washersafedetergents/soaps. Follow all
manufacturers instructions.
Cleaning and ApplyingDetergent with the
Project Pro@ PerfectMix
TM
Siphon
To apply undiluted detergent using the blue
PerfectMix
TM
siphon, follow these steps:
1. Review use of spray tips.
2. Attach PerfectMix
TM
siphon hose to pump
and PerfectMix
TM
concentrate bottle.
13