Assembly; Tools Required For Assembly; To Remove The Snow Thrower From Carton - Sears Craftsman 536.886121 Owner's Manual

H ,,,,,i ,,i IIIIH,.I. II.I I I ,I Illll II I ,/'/ I,,,,,,, .....
AS LY
TOOLS REQUIRED FOR ASSEMBLY ......................................................
1 - Knife (to cut carton and plastic ties)
2 - !12 inch wrenches (or adjustable wrenches)
2 - 9116 inch wrenches (or adjustable wrenches)
2 - 3/4 inch wrenches (or adjustable wrenches)
t - Pliers (to spread cotter pin)
I- Screwdriver
1 - Measuring Tape or Ruler
Figure 1 shows the snowthrower in the shipping position
Figure 2 showsthe snowthrowercomptetely assembled
Reference to the right and left hand side of the snow
thrower is from the operator's position at the handle
TO REMOVE SNOW THROWER
FROM CARTON (See Fig. 1)
® Locate and remove container of 5W30 oil
• Locate the crank assembly and place the assembly
as{de,
O
O
® Remove and discardthe packing materialfrom around
snow thrower,
® Cut all four comers of the carton from top to bottom
and lay the panels flat.
e Cut ties securing the clutch control cables to the lower
handle and lay cables back away from the motor
frame°
Roll the snowthrower off the carton by puli_ng on the
lower handle_ CAUTION: DO NOT back over cable.
To complete upper handle installationand install
chute crank assembly, see To Install The Upper
Handle and Crank Assembly paragraph on page 8
NOTE: Itthe cables have become disconnected from the
clutch levers, reinstall the cables as shown in Fig, 3 and
Fig, 3Ao
i i ill iqt ii mE HqLI II
........... 4" LG FREE
STATE 3" LG FREE
STATE
TRACTION __ AUGER
DRIVE.,.. / DRIVE
SPRING_\..
J SPRING
tRACTION _"__
_--"_ f_ AUGER
DRIVE
_1_"//,,
_,_DRIVE
SPR|NG-.._
_ H
SPRING
LEVER 1___2 ...... i ,;,,'i,,,i,,ii'i,i, _ CABLE,
FIG. 3A
CAU]ION :IF YOUARE REMOVING SNOW
FROM ANY GRAVELED OR UNEVEN
SURFACE, RAISE THE FRONT OF THE
SNOW THROWER BY MOVING THE
SKIDS DOWN. THIS WiLL HELP TO PRE-
VENT STONES AND OTHER DEBRIS
FROM BEING PICKED UP AND THROWN
BY THE AUGER.
LOWE HANDLE
SHIFTER
PLATE
UPPER
HANDLE
ASSEMBLY
FIG. 1
ADJUST SKID
FIG. 2
DRIVE
LEVER
FIG. 3
7