Switching The Frequency To Display; Alarm Messages - Furuno NX-700A/B Operator's Manual

2. OPERATION
2.9

Switching the Frequency to Display

With showing the message list, you can switch the frequency to 518 kHz or 490
(or 4209.5) kHz by pressing ◄ or ► key.
2.10

Alarm Messages

The sequence of events when an alarm message is received is as shown below.
When receiving SAR (Search and Rescue) message:
The audible alarm beep sounds, and the SAR message is shown. Note that All
Messages list appears if other list option is chosen when the ENT key is pressed.
(See paragraph 2.11.) The aural alarm sounds medium beep.
When receiving WARNING message (A/B/L):
When the Warn Msg Alm on System menu is set to On, the audible alarm
sounds and the message for receiving appears. The aural alarm sounds long
beep.
Note: When both alarms are received, the aural alarm sounds short beeps.
Silencing audible alarm
Press any key (except
2-8
518
Switching the frequency to display
key).
Press
490 (4209)