COMPANION 137.232040 Operator's Manual page 9

ASSEMBLE STAND (Fig.A)
1. Unpack allparts andgroup by typeandsize(seeFig.1).
Refertothepartslistforcorrect q uantities.
2. Attachonelonguppersupport ( 4)to topof
leg (1) using
one square neck bolt (2) and nut (5).
NOTE: Do not tighten bolts until stand is properly
aligned (see step #8 before tightening).
3. Attach other end of long upper support to top of another
leg using one square neck bolt and nut.
4. Attach one long bottom support (3) to center of each leg
using square neck bolts and nuts. This completes the
front frame section.
5. Assemble rear frame section in exactly the same
manner.
6. Join front and rear frame assemblies using two short
upper supports (11 ) and two short bottom supports (10),
square neck bolts and nuts.
7. Insert foot pad (6) into bottom of leg. Repeat for each
leg.
8. Place stand on level surface and adjust so all legs are
contacting the floor and are at similar angles to the floor.
Tighten all bolts.
NOTE: Stand should not rock after all bolts are
tightened.
Fig. A
Assemble table saw to stand (Fig. A-l)
1. Place protective cardboard or old blanket on floor to
protect the saw table surface.
2. Place the saw up side down on the protective material
(see Fig. A-l).
3. Position the stand up side down on the saw base.
NOTE: Make sure front of stand (identified with label)
and front of saw are facing the same direction.
4. Line up four holes in saw base and stand.
5. Fasten saw to stand using four bolts (12), washers (13)
and nuts (14).
NOTE: Place washer on each bolt before inserting into
saw base and through the support. Nut must be
immediately against the bracket (see Fig. A).
6. Tighten all four nuts.
NOTE: DO NOT OVER TIGHTEN NUTS HOLDING
SAW TO STAND. THIS MAY DAMAGE THE SAW
BASE.
7. Carefully set the saw in its upright position on a clean
level surface.
I_ CAUTION I
DO NOT OPERATE THIS MACHINE ON THE FLOOR.
THIS IS A VERY DANGEROUS POSITION.
Fig. A-1
12 I
13
Left side of Front of
stand stand
1