Bevel Pointer Adjustment - COMPANION 137.232040 Operator's Manual

0° BEVEL STOP (FIG. S )
1. Raise thebladetomaximum height b yrotating
thehandwheel counter c lockwise.
2. Loosen bevel a nglelockknob.
3. Tiltthebladeto 0° bevel.
4. Using a square (1),verifybladeis 90°tothe
tabletop.
5. If bladeis not90° tothetable,adjust t hescrew
(2)inoroutaccordingly.
6. Loosen bevel l ockknobandrecheck squareness
asdescribed instop5 & 6 untilbladeis 90°to
table.
7. Once bladeisat 90 ° tothetabletop,lockbevel
anglelocking knob.
8. Carefully t ighten adjusting screw(2)untilit
touches thebevel s top. DONOTOVER
TIGHTEN.
9. Recheck t oensure bladeis stillaligned at90°.
Fig. S
45 ° BEVEL STOP (FIG. U)
1. Raise the blade to maximum height by rotating
the handwheel counter clockwise.
2. Loosen bevel angle lock knob.
3. Tilt the blade to 45 ° bevel.
4. Using a square (1), verify blade is 45 ° to the
table top.
5. If blade is not 45 ° to the table, adjust the screw
(2) in or out accordingly.
6. Loosen bevel lock knob and recheck squareness
as described in stop 5 & 6 until blade is 45 ° to
table.
7. Once blade is at 45 ° to the table top, lock bevel
angle locking knob.
8. Carefully tighten adjusting screw (2) until it
touches the bevel stop. DO NOT OVER
TIGHTEN.
Recheck to ensure blade is still aligned at 45 °.
Fig. U
1
o°/2
o o
BEVEL POINTER ADJUSTMENT (FIG. T)
1. Set bevel angle in vertical position.
2. If the pointer (1) does not read 0°, loosen pointer
screw (2) and move the pointer so it reads
correctly.
3. Retighten the pointer screw.
Fig. T