Full One Year Warranty - COMPANION 137.232040 Operator's Manual

SECTION PAGE
Warranty ........................................ 2
Product Specifications ....................... 2
Power Tool Safety ............................ 3
Table Saw Safety .............................. 4
Electrical Requirements and Safety ...... 5
Accessories and Attachments .............. 6
Tools Needed For Assembly ................ 6
Carton Contents .............................. 6
SECTION PAGE
Know Your Table Saw ....................... 8
Assembly and Adjustments ................. 9
Operation ....................................... 17
Maintenance ................................... 21
Troubleshooting Guide ....................... 22
Push Stick Pattern ........................... 23
Parts List ........................................ 24
FULL ONE YEAR WARRANTY
If this Table Saw fails due to a defect in material or workmanship within one year of date of purchase,
Sears will at its option repair or replace it free of charge.
Return this Table Saw to a Sears Service Center for repair, or to place of purchase for replacement.
This warranty gives you specific legal rights, and you may also have other rights which may vary from
state to state.
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals, work in a well-ventilated area and work with approved safety equipment such as dust masks
that are specially designed to filter out microscopic particles.
MOTOR
HP (Maximum developed) ..... 2.5
Type .................................. Universal
Amps ................................. 13
Voltage .............................. 120
Hz ...................................... 60
RPM (no load) .................... 5000
Overload Protection ............. YES
SAW
Table Size ........................ 26 1/8" x 16"
Table Extension
................. Right Side - 8" Steel
Rip Capacity with Extension. 17-5/8"
Blade Size ........................ 10"
Rip Fence ........................ YES
Miter Gauge ...................... YES
Maximum Cut Depth @ 90°.. 3"
Maximum Cut Depth @ 45°.. 2-1/2"
Maximum Diameter Dado .... 6"
Maximum Dado Cut Width... 1/2"
Net Weight ...................... 54 LBS
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt / 15 Ampere
time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow these
rules could result in serious injury to you or damage to the table saw.