COMPANION 137.232040 Operator's Manual page 11

1. Liftupward onripfencehandle (2)sotherear
holding clamp isfullyextended..
2. Place theripfenceonthesawtable, e ngaging
therearfenceclamp firstthenlowering t hefront
endontothetable.
3. Pushdownonthefencehandle to lock.
Fig. E
5
--" I
TABLE EXTENSION - RIGHT SIDE (FIG. F)
1. Group like bolts and washers.
2. Thread the three adjusting bolts (1) into the
threaded holes of the extension as shown. Do
not thread bolts beyond the end of the extension.
3. Place a lock washer (3) followed by the flat
washer (5) on bolt (4). Repeat for remaining two
mounting bolts.
4. Position the extension (6) next to the saw table
on the right sid (7) and align the mounting holes.
5. Place the bolts and washers into the three holes
at the right side of the saw table as shown.
6. Place a washer (8) and nut (9) on the threaded
end of each bolt, and hand tighten.
7. Lay a straight edge on the saw table and over
the extension (6). Turn the three adjusting
screws (1) in or out accordingly until the
extension is flush with the top of the saw table.
8. Tighten the mounting bolts.
9. Attach the rip scale (10) to the table extension
accordingly.
Fig. F
8
INSTALLING AND CHANGING THE BLADE
(FIG. H, I, J)
• To avoid injury from an accidental start, make
sure the switch is in the OFF position and the
plug is not connected to the power source
outlet.
• To avoid serious injury, table insert must be
level with the table, tf the table insert is not
level with the table, adjust the screw (3) until it
is level with the table. To raise the insert, turn
the screw counterclockwise, to lower the insert,
turn the screw clockwise. Note: A rubber
adjusting spacer is provided under rear of
insert for this purpose.
1. Remove the table insert (1) by removing the two
screws (2, 3). Be careful not to lose the rubber
spacer that is on the back screw (3) beneath the
table insert. (Fig. H)
Fig. H
_3
2. Raise the blade arbor (4) (Fig. 1) to the maximum
height by turning the blade raising handwheel
counterclockwise.
3. Place the open-end wrench jaws on the flats of
the saw arbor to keep the arbor from turning. (Fig.
J) and place the box-end wrench (8) on the arbor
nut (5), and turn counterclockwise.