Fujitsu MB39A104 Datasheet page 34

MB39A104
■ USAGE PRECAUTIONS
• Printed circuit board ground lines should be set up with consideration for common impedance.
• Take appropriate static electricity measures.
• Containers for semiconductor materials should have anti-static protection or be made of conductive material.
• After mounting, printed circuit boards should be stored and shipped in conductive bags or containers.
• Work platforms, tools, and instruments should be properly grounded.
• Working personnel should be grounded with resistance of 250 kΩ to 1 MΩ between body and ground.
• Do not apply negative voltages.
• The use of negative voltages below −0.3 V may create parasitic transistors on LSI lines, which can cause
malfunction.
■ ORDERING INFORMATION
Part number
MB39A104PFV-❏❏❏E1
■ EV BOARD ORDERING INFORMATION
EV board part No.
MB39A104EVB
■ RoHS COMPLIANCE INFORMATION OF LEAD (Pb) FREE VERSION
The LSI products of Fujitsu Microelectronics with "E1" are compliant with RoHS Directive , and has observed
the standard of lead, cadmium, mercury, Hexavalent chromium, polybrominated biphenyls (PBB) , and polybro-
minated diphenyl ethers (PBDE) .
The product that conforms to this standard is added "E1" at the end of the part number.
■ MARKING FORMAT (Lead Free version)
INDEX
34
Package
24-pin plastic SSOP
(FPT-24P-M03)
EV board version No.
Board Rev. 1.0
3 9A 04 1
XXXX
XXX
E1
Remarks
Lead Free version
Remarks
SSOP-24P
Lead Free version