Loading Paper - Epson Stylus Photo RX500 Owner's Manual

EPSON Stylus Photo RX500
Mechanical
Paper feed method Friction
Paper path Sheet feeder, top feed
Sheet feeder
capacity Approx. 80 sheets at 24 lb (90 g/m
Dimensions 17.7 × 23.3 × 11.9 inches (W × D × H)
449.6 × 592 × 302.3 mm (W × D × H)
Weight Approx. 19.21 lb (8.7 kg)
Electrical
Input voltage range* 108 to 132 V
Rated frequency
range 50 to 60 Hz
Rated current 0.8 A
Power consumption Approx. 21 W (ISO 10560 Letter
Pattern)
Approx. 4.0 W in sleep mode
Approx. 0.4 W in power-off mode
* Check the label on the back of this product for voltage information
Environmental
Temperature
Operation 50 to 95 °F (10 to 35 °C)
Storage* – 4 to 140 °F (– 20 to 60 °C)
1 month at 104 °F (40 °C)
Transit* – 4 to 140 °F (– 20 to 60 °C)
120 hours at 140 °F (60 °C)
Humidity (without condensation)
Operation 20 to 80% RH
Storage* 5 to 85% RH
* Stored in shipping container
Interface
Standard Based on Universal Serial Bus
Specifications Revision 2.0, Universal
Serial Bus Device Class Definition for
Printing Devices version 1.1
Bit rate 480 Mbps (high speed device)
Data encoding NRZI
Connector USB Series B
Recommended
cable length 6.6 feet (2 meters)
EPSON Stylus Photo RX500
4 -
Safety Approvals
Safety standards
EMC
)
2

Loading Paper

Single Sheets
1. Open the output tray.
2. Pinch the sides of the left edge guide together as you slide
the guide all the way to the left.
3. Flip the feeder guard forward.
Feeder guard
4. Insert your paper against the right edge of the sheet feeder.
Then pinch the sides of the left edge guide together as you
slide it against the paper (but not too tightly).
5. Lower the feeder guard back over the paper.
Also be sure to:
❏ Load the printable side face-up. It's often whiter or brighter
than the other side.
❏ Load letterhead or preprinted paper top edge first.
❏ Load paper short-edge first, even for landscape-oriented
documents and photos.
❏ Don't load paper above the arrow on the left edge guide.
❏ Load up to approximately 80 sheets of plain paper at a time.
❏ If the paper has a cut corner, position it in the upper right
corner as you load it in the sheet feeder.
10/03
UL 60950, CSA C22.2 No. 60950
FCC part 15 subpart B class B
CSA C108.8 class B
Output tray