Table of Contents
Advertisement
Power on
Reset
TARGET RESET
Transciever Mode Changed to SINGLE-ENDED
Transciever Mode Changed to LVD
Mode parameters changed
Reservations Preempted
Reservations Released
Registrations Preempted
Commands cleared by another INIT
Spindle synchronized
Spindle not synchronized
Microcode has been changed
Changed Operating Definition
Device Identifier Changed
However, if the IDD responds with a BUSY status or QUEUE FULL status due to its not being able to
receive the command that was issued, the UNIT ATTENTION condition is not cleared.
The above CHECK CONDITION status response that is the cause of the UNIT ATTENTION
condition hold can be prohibited by the specification of the CHANGE DEFINITION command.
When the CHECK CONDITION status response is prohibited, the IDD executes the commands it
receives normally, except in the case of a RESERVATION CONFLICT status, BUSY status or
QUEUE FULL status. In this case, the UNIT ATTENTION condition for the INIT that issued that
command is cleared.
See Section 3.1.4 "CHANGE DEFINITION" concerning setting details.
(2)
INQUIRY command
The INQUIRY command is executed normally, but the UNIT ATTENTION condition is not cleared.
(3)
REQUEST SENSE command
One of the following operations is performed depending on whether or not the IDD is in the sense
data hold state (shown in Section 1.6).
a. In the case of a Sense Data Hold state
The IDD executes the REQUEST SENSE command normally and sends the sense data which are
being held to the INIT. In this case, the UNIT ATTENTION condition is not cleared.
b. In the case of a State other than a Sense Data Hold state
C141-E167
1.5 UNIT ATTENTION Condition
[=29-01]
[=29-02]
[=29-03]
[=29-05]
[=29-06]
[=2A-01]
[=2A-03]
[=2A-04]
[=2A-05]
[=2F-00]
[=5C-01]
[=5C-02]
[=3F-01]
[=3F-02]
[=3F-05]
1 - 21
Advertisement
Table of Contents
