Table of Contents
Advertisement
Command Specifications
Error recovery processing during execution of this command is in accordance with the specifications
in (Page code 1: Read/Write Error Recovery Parameter, Page code 21: Additional error recovery
parameters).
The ARRE flag and the DTE flag are not applied.
The TB flag is treated as if "1" was specified.
3.4.6
WRITE LONG (3F)
Bit
Byte
0
1
2
3
4
5
6
7
8
9
This command writes the data block data transferred from the INIT, together with the ECC to form
bytes, in the logical data blocks on the disk media specified in the "Logical block address" field in
the CDB. Normally, this command is used for checking the ECC function in combination with the
READ LONG command.
The object of this command's operation is only 1 data block. Also, the data transferred from the
INIT by this command must have the same order and the same length as the data transferred to the
INIT from the IDD by the READ LONG command.
The "Transfer byte length" field in the CDB indicates the number of bytes of data transferred from
the INIT by this command. When the "Transfer byte length" specification is zero, this command is
terminated normally without performing anything.
If a value specifying a length (other than zero) that does not match the data format on the disk media
is specified in the "Transfer byte length" field in the CDB, that command is terminated with a
CHECK CONDITION status without data being transferred to the INIT. The sense data at this time
indicate the following contents and the INIT can determine the correct "Transfer byte length" from
their contents.
112
3 -
7
6
5
LUN
Logical Block Address (MSB)
Logical Block Address
Logical Block Address
Logical Block Address (LSB)
0
0
0
Transfer Byte Length (MSB)
Transfer Byte Length (LSB)
0
0
0
4
3
2
X'3F'
0
0
0
0
0
0
0
0
0
1
0
0
0
0
0
0
Link
C141-E167
Advertisement
Table of Contents
