Fujitsu MAP3147 Scsi Logical Interface Specifications page 243

C* Q* Name
3D 00 Invalid bits in IDENTIFY
message
3E 03 Logical unit failed Self-
Test
04 Logical unit unable to update The IDD failed to update the Self-Test result log
3F 01 Microcode has been changed Microcode was changed by another INIT.
02 Changed operating
definition
05 Device identifier changed
40 nn Diagnostic failure on
component "nn"
43 00 Message error
44 nn Internal target failure
* C: Sense Code, Q: Sub-sense Code
C141-E167
Table 5.2 Sense and subsense codes (4 of 5)
"1" was specified in the reserve bit of the IDENTIFY message.
The test segment error occurred during the Self-Test
Operating definition was changed.
Device identifier was changed.
An error was detected in self-diagnosis. ("nn" is a Fujitsu unique
code)
• 81: Buffer RAM compare error/bus error
• 82: Program RAM compare error/bus error
• 83: HDC register check error
• 84: Firmware header/check sum error
• 85: Firmware type unmatch
• 86: Parameter header/check sum error
• 88: Drive Serial No. unmatch
• 89: DE type unmatch
• 8F: Other MPU peripheral circuit diagnostic error
• 92: Spindle motor firmware initialize error
A message sent by the IDD was illegally rejected.
An error was detected in self-diagnosis. ("nn" is a Fujitsu unique
code)
• 90: Next sector IDD compare error
• 91: WCS RAM parity error
• 92: Unexpected FMT interrupt
• 94: NRZ parity error during Write (MAS3*** Series only)
• 99: Overflow error occurred at SPC FIFO
• 9A: Unexpected SPC interrupt
• 9B: SPC detected illegal command interrupt
• 9C: SPC detected illegal write interrupt
• 9D: SPC detected Sync offset error interrupt
• A0: Error interription from DBM
• A3: DBM buffer CRC error
• A4: DBM internal parity error
• A8: Data late error
• B0: Flash ROM erase operation failed.
• B1: Flash ROM write operation failed.
• C0: RDCLK error (FMT hang up)
• D1: DSP downloading failed
• D2: DSP overrun (watch dog time out, DRV hard error)
• D3: Servo Gate Window error
• D4: Illegal error was reported from DSP
• E0: Any error detected during calibration
Explanation
5.1 Sense Data
Sense
key
5
4
4
6
6
6
4
B
4
5 - 9