General Maintenance - Craftsman 315.114233 Operator's Manual

,&
4_, WARMNG: Before performing any adjustment,
make sure the battery pack is removed from too(.
Fa((ure to heed th(s warn(ng cou(d resu(t in sedous
persona( injury.
ADJUST(NG THE LASER
See Figure 26.
NOTE: Draw a pencil (ine on a scrap workpiece para((e( to
the (ong edge of the base as a straight line guide to aid in
the adjusting process.
[] Remove battery pack from the trim saw.
[] Make sure (aser is turned off.
[] Remove the (aser cover by lifting (t off its base.
[] Turn (aser on.
[] Loosen the screw inside laser.
[] Rest the front of the base on scrap workpiece.
[] Adjust the (aser beam with the mark on the scrap
workp(ece by (oosening the screw to the (aser aperture
and s(ow(y moving (aser guide (eft or r(ght.
[] Since Made thicknesses vary, a(ways make a trial cut in
scrap workpiece to ensure an accurate cut.
[] Once alignment is achieved tighten the screw.
[] Rep(ace the (aser cover.
[] Check for proper a(ignment.
[] Repeat as necessary until laser is aligned.
%
LONGEDGE
OF BASE
F(g. 26
_, WARNING: When servicing, use only (dentical
Craftsman rep(acement parts. Use of any other part
may create a hazard or cause product damage.
_ WARN(NG: Always wear safety goggles or safety
glasses with side shields when using compressed air
to clean too(s. (f the operation is dusty, also wear a
dust mask.
_ WARNING: To avoid ser(ous personal injury, always
remove the battery pack from the too( when c(eaning
or performing any maintenance.
GENERAL MAINTENANCE
Avoid using so(vents when c(eaning p(astic parts. Most
plastics are susceptib(e to damage from various types of
commercia( solvents and may be damaged by their use.
Use c(ean c(oths to remove dirt, dust, oi(, grease, etc.
_ WARMNG: Do not at any time let brake fluids,
gaso(ine, petroleum-based products, penetrating
ells, etc. come in contact w(th plastic parts. Chemi-
ca(s can damage, weaken or destroy plastic which
may result in ser(ous personal injury.
Only the parts shown on the parts (ist are intended to be
repaired or replaced by the customer. A!l other parts
shou(d be replaced at a Sears Service Center.
21