Craftsman 315.114233 Operator's Manual page 13

CHARGmNG A HOT BATTERY PACK
When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
NOTE: This situation only occurs when continuous use of
your drill causes the batteries to become hot. Htdoes not
occur under normal circumstances. Refer to "CHARGING
THE BATTERY PACK" for normal recharging of batteries.
Hfthe charging assembly does not charge your battery
pack under normal circumstances, return both the battery
pack and charging assembly to your nearest Sears Repair
Center for electrical check.
ADAPTEB
BATTEBY
CHABGE
INDICATOBLIGHT Fig. 5
TO mNSTALL BATTERY PACK
See Figure 6.
NOTE: Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to page
12, "Charging Battery Pack" for charging instructions.
[] Place battery pack in the saw. Align raised rib on battery
pack with groove inside saw, then slide battery pack in
saw.
[] Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in saw before
beginning operation.
LATCHES
!
BATTEBYPACK
Fig. 6
_ CAUTION: When placing battery pack in the saw,
be sure raised rib on battery pack aligns with groove
inside saw and latches snap into place properly.
Improper assembly can cause damage to saw and
battery pack.
13