Internal Connectors - Asus RAMPAGE III EXTREME User Manual

2.9.4

Internal connectors

1. ICH10R Serial ATA connectors (7-pin SATA 1-6 �grey�) ICH10R Serial ATA connectors (7-pin SATA 1-6 �grey�)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives and optical disc drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5,
and 10 configuration with the Intel
onboard Intel
®
• These connectors are set to Standard IDE mode by default. In Standard
IDE mode, you can connect Serial ATA boot/data hard disk drives to these
connectors. If you intend to create a Serial ATA RAID set using these
connectors, set the Configure SATA as item in the BIOS to [RAID]. See
section 3.4.5 Storage Configuration for details.
Before creating a RAID set, refer to section 4.4 RAID configurations or the
•
manual bundled in the motherboard support DVD.
• You must install Windows
Serial ATA hard disk drives. The Serial ATA RAID feature is available only if
you are using Windows
When using hot-plug and NCQ, set the Configure SATA as in the BIOS to
•
[AHCI]. See section 3.4.5 Storage Configuration for details.
ROG Rampage III Extreme
ICH10R RAID controllers.
®
XP SP2 or later versions.
®
Matrix Storage Technology through the
®
XP Service Pack 2 or later versions before using
2-39