Replacing Ink Cartridges - Epson STYLUS 7890 User Manual

Tip: You can store
partially used ink
cartridges for up to
6 months. If you do so,
Epson recommends
covering the openings
with tape.
Maintaining and Transporting the Printer
3. Press u or until
d
PAPER THICKNESS
4. Press r two times, then select the paper type loaded in the printer and
press .
OK
5. Press l three times, then press d to select
6. Press r to select
AUTO
highlighted. This is the type of alignment to start with.
7. Press r, then press
Each head alignment takes about 7 minutes. The printer's white beam
sensor reads the alignment pattern and adjusts the printer automatically.
Make sure you don't open the front cover or turn off the printer during
this process.
8. When the uni-directional alignment is finished, press r.
9. Select
HEAD ALIGNMENT
10. Select and press
BI-D ALL
11. When done, press

Replacing Ink Cartridges

Before you begin a large print job, you should check your ink levels. If one of
your cartridges is low, you can replace it before you start. Or you can wait
until the ink is expended, replace the cartridge, and then continue the job
without any loss of print quality. However, it is best to replace a low ink
cartridge before starting a large print job.
The easiest way to check ink levels is from the control panel LCD screen.
The numbers above the ink icons on the LCD screen correspond to the
9 ink cartridge slots on the printer.
The icons show the approximate amount of ink remaining.
153
HEAD ALIGNMENT
is selected.
, then press r again.
to start the alignment process.
OK
, then select
ALIGNMENT
to start the alignment process.
OK
to exit head alignment mode.
is selected, then press r.
.
ALIGNMENT
(uni-directional) is
UNI-D
.
| 153