Table of Contents
Advertisement
Tile TV will not turn orl.
•
Make sure the AC power cord is securely plugged in to the wall outlet and the T_4
•
Make sure the wall outlet is working.
•
Try pressing the POWER button on the TV to make s_re the problem is not the remote.
If the -P,/turns on, refer to 'Remote control does not work' below.
Tile TV turns off automatically.
•
Ensure the Sleep Timer is set to Off in the Setup menu. (R 18)
•
If your PC is connected to the TV, check your PC power settings.
•
Make sure the AC power cord is plugged irl securely to the wall outlet and the T_4
•
When watching ]-V from an antenna or cable connection, the TV will turn off after 10 - 15
minutes if there is no signal.
There is rio picture/video.
,,
Check cable connections. (remove and reconnect all cables connected to the ]-V and external
devices).
•
Set your external device's (Cable/Sat Box. DVD, Blu-ray etc) video outputs to match the
connections to the TV input. For example, if an external device's output is HDMI, it should be
connected to an HDMI input on the T_4
,,
Make sure your connected devices are powered on.
,,
Be sum to select tile TV's correct source by pressing the SOURCIE button on the remote
control.
,,
Reboot the connected device by recorlrlecting the device's power cable.
The TV is not receMng all channels.
*
Make sure the coaxial cable is connected securely.
,,
Please try Auto Program to add available channels to the channel list.
go to MENJ - Channel o Auto Program then select Auto and make sum correct Cable 3-V
signal type is set in tile menu. There are 3 options. (STD, HRC and IRC) (P. 12)
•
Verify the Antenna is positioned correctly.
No Caption on digital channels.
•
Check Caption Setup menu. -fry changing Caption Mode Service 1 to COl. (R 20)
,,
Sorrle channels may not have caption data.
Tile picture is distorted: macroblock,
,,
Compression of video contents may cause picture distortion, especially on fast moving pictures
error, small block, dots, pixelization,
such as sports and action movies.
,,
A low signal can cause picture, distortion. This is not a %/problem.
A "Mode Not Supported"
message
*
Set your PC's output resolution so it matches the resolutiorls supported by the %/.
appears.
"PC" is always shown on the source
,,
This is normal; "PC" is always shown on tile source list, regardless of whether a PC is
list, even if a PC is not connected,
connected.
The video is OK but there is no audio.
,,
If you are using a HDMI connection, check the audio output setting on your PC.
The wireless network connection failed.
*
Samsung Wireless USB dongle is required to use a wireless network.
•
Make sure the Network Connection is set to Wireless. (R 26)
•
Make sure the TV is connected to a wireless IP sharer (Router).
Software Upgrade over tile network
•
Try network test in Setup menu. (R 25, 27)
fails.
,,
If you have latest SW version, SW upgrade will not proceed.
.gli h 47
Hide quick links:
Advertisement
Table of Contents
