Samsung LN40C630 Operator's Manual page 29

9. When done, press the Blue button on your remote, The
Network Connecting screen appears,
10. W ait until the connection confirmation message is
displayed, and then p ress the ENTER _ button, The
Network Setup screen re-appears,
11. T o test the connection, press the RETURN button to
sebct Network Test, and t hen p ress the ENTERIZ_
button,
Network SetuP (Adl Hoc )....................................................................................................
You can connect to a mobib device without an access point
through the "Samsung Wireless LAN Adapter" by using a
peer to peer network,
This function is available when SWL(Samsung
Wireless Link) is set to Off in the TV's on-screen
menu.
How to connect to new Ad-hoc
1. Follow Steps 1 through 6 in the "How to set up using
PBO(WPS)", (R 28)
2. Choose Select a network, A list of devbes/networks
appears,
3. Whib in the device list, press the Blue button on the
remote,
The message "Ad-hoc is a direct WPFi
connection with cellphone or PC. The existing
network system may have limited functionality.
Do you want to change the network
connection?"' is displayed,
4. Input the generated Network Name (SSmD) a nd
Security Key into the device you want to connect
How to connect an existing Ad-hoc device
1. Follow Steps 1 through 6 in the "How to set up using
PBO(W!PS)",(R 28)
2. Choose Select a network, Then, the device list will be
displayed,
3. Select the device you want in the Device list,
4. If security key was applied, input the security key,
If network does not operate normally, check
the Network Name (SSmD)and Security Key
again, An incorrect Security Key may cause a
malfunction,
Network Setu p (Manual) ....................................................
If the other methods do not work, you need to enter the
Network setting values manually,
Getting the Network Connection Values
To get the Network setting values on most Windows
computers, follow these steps:
1. Right click the Network icon on the bottom right of the
screen,
2. In the pop-up menu, click Status,
3. On the dialog that appears, click the Support tab,
4. On the Support tab, click the Details button, The
Network settings are displayed,
How to set up manually
To enter the Network connection values manually, follow
these steps:
1. Follow Steps 1 through 6 in the "How to set up using
PBO(WPS)', (R 28)
2. Press the _' button to select Internet Protocol Setup,
and then press EN°I°ERC_ button, Press the a, or _"
button to select Manual, and then press ENTER _
button,
3. Press the T button to go to the first entry field (IP
Address),
4. Use the number buttons to enter numbers,
5. When done with each field, use the _- button to move
successively to the next field, You can also use the other
arrow buttons to move up, down, and back,
6. Enter the IP Address, Subnet Mask, and Gateway
values,
7. Press the A or _" button to go to DNS,
8. Press the T button to go to the first DNS entry field,
Enter the numbers as above,
9. When done, press the a, button to go to Select
a Network Select your network, and then press
ENTER _ button.
10. Go to Step 4 in the "How to set up automatically" (R 28),
and follow the directions from that point on.
English 29