BLY
CONNECT
BATTERY
(See Figs. 2 and 3)
i
CAUTION: Do not short battery termi-
nals.
Before connecting battery, re-
move metal bracelets,
wristwatch
_
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
• : Remove cardboard packing from seat pan and lift seat
pan to raised position.
•
Open battery box door.
•
Remove terminal protective caps and discard.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
•
First connect RED battery cable to positive (+) terminal
with hex bolt, flat washer, lock washer and hex nut as
: shown. Tighten securely.
•
Connect BLACK grounding cable to negative (-) termi-
na wth remain ng hex bolt, flat washer lock washer
:
and hex nut. Tighten securely.
•
Close battery box door.
Open battery box door for:
•
Inspection for secure connections (to tighten hard-
ware),
•
Inspection for corrosion ....
:
•
Testing battery.
•
Jumping (if required).
•
Periodic charging.
DISCARDTERMINALPROTECTIVE
CAPS
POSITIVE
/
(RED)CABLE_
LOCK
HEX
WASHER
NUT
FLAT
_t
WASHER
FIG, 2
BOLT
NEGATIVE
(BLACK) CABLE
SEAT
PAN
BOX DOOR
FIG. 3
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment bolt.
•
Remove cardboard packing on seat pan.
•
Place seat on seat pan and assemble shoulder bolt.
•
Assemble adjustment bolt, lockwasher and flat washer
loosely. Do not tighten.
•
Tighten shoulder bolt securely.
•
Lower seat into operating position and sit on seat.
•
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down.
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment bolt securely.
SEAT PAN
SHOULDER
_
BOLT
g
ADJUSTMENT
BOLT
,,,_
FLAT WASHER
LOCK
WASHER
FIG. 4
•:8