Table of Contents
Advertisement
SERVICE AND ADJU
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straightforward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
_
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor.
If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 24)
i ....
•
Block up axle securely.
°
Remove axle cover, retaining ring and washers to aliow
.
wheel removal (rear wheel contains a square key - Do
not lose).
•
Repair tire and reassemble.
°
On rear wheels only: align grooves in rear whee hub
and axle. Insert square key.
°
Replace washers and snap retaining ring securely in
axle groove ..........
°
Replace axle cover.
WASHERS
RETAINING
RING
AXLE COVER
SQUARE KEY
(REAR WHEEL ONLY)
FIG. 24
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 25)
teries.
if your battery is too weak to start the engine, it should be
recharged.
If "jumper
cables"
are used for emergency
starting, follow this procedure:
IMPORTANT:
YOUR TRACTOR
IS EQUIPPED
WITH A 12
VOLT NEGATIVE
GROUNDED
SYSTEM.
THE OTHER
VEHICLE
MUST
ALSO
BE A 12 VOLT
NEGATIVE
GROUNDED
SYSTEM.
DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
°
Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis.
•
Connect one end of the BLACK cable to the NEGA-
TIVE (-)terminal of fully charged battery.
•
Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tankand battery.
TO REMOVE CABLES, REVERSEORDER
-
•
BLACK cable first from chassis and then from the fuliy
charged battery.
•
RED cable last from both batteries.
POSITIVE TERMINAL
NEGATIVE TERMINAL
POSITIVE TERMINAL
\
NEGATIVETERMINAL
FIG. 25
22
Advertisement
Table of Contents
