Advertisement
6. Attach thelastlower support r odtotheoutsideofthe
topanglesupport u singtwo1/4"x 3/4"hexboltsand
1/4"locknuts. D ONOT TIGHTEN Y ET.Seefigu re 19.
NOTE: C artbagnot shownfor
clarity.
LOWER ROD
(BENT)
1/4" x 3/4"
\
HEX BOLT
FIGURE 19
7. Attach the braces to the front support tube using two
1/4" x 1-1/4" hex bolts and 1/4" lock nuts. DO NOT
TIGHTEN YET. See figure 20.
NOTE: Cart bag not shown for clarity.
I/4" LOCK
NUT
1/4" x 1-1/4"
HEX
BOLT
FIGURE 20
While
performing
the assembly
operations
in step 8, make sure the cart
bag is between
the top angle support
and the cart.
,
Place the top angle support and cart bag ontop of the
cart as shown in figure 21. Then, using a screwdriver
or other sharp object, poke holes through the cart bag
for the bolts that will be assembled in step 9.
,
Attach the top angle support and braces to the cart
using five 1/4" x 3/4" hex bolts, two 1/4" x 1" hex bolts
through braces, fourteen 5/16" washers (one placed
on each side) and seven 1/4" nylock nuts. DO NOT
TIGHTEN YET. See figure 21.
10. TIGHTEN all bolts assembled in steps 4 through 9.
NOTE: Most of cart bag not shown for clarity,
BAG
FIGURE 21
14
Advertisement
