Advertisement
,
Attach the engine mounting plate to the tongues
using two 3/8" x 3" hex bolts in the back holes, two
3/8" x 1" hex bolts in the front holes and four 3/8"
nylock nuts. See figure 9.
HINT:
For easier assembly, support the rear tongue with
a block of wood.
13. Place a hose clamp onto the end of the hose. Push
the hose onto the hose adapter (nozzle). Tighten the
hose clamp onto the hose and hose adapter. Do not
collapse the hose adapter when tightening the clamp.
See figure 11.
14. The remaining hose clamp will be used later to fasten
the hose to the deck adapter.
3/8" x 3"
HEX BOLT
t
i
318"NYLOCK NUT -_ 6'
HEX BOLT
FIGURE 9
HOSE ADAPTER
(NOZZLE)
CLAMP
HOSE
FIGURE 1 1
13. Place the hose hanger rod assembly down into
the hose hanger bracket on the impeller housing
assembly. See figure 10.
HOSE
HANGER
ASSEMBLY
\
FIGURE 10
11
Advertisement
