Download Print this page

Craftsman 486.24506 Operator's Manual page 20

5 hp

Advertisement

BEFORE
STARTING
Your Vac System engine is shipped without oil or
gasoline. Service the engine with oil and gas as
instructed in the separate engine manual.
Inspect the Vac System to make sure all covers (rear
door, hardtop boot, elbow, hose adapter, hose and
deck adapter are properly attached.
Check tires for proper inflation (12 - 14 Ibs).
,_
WARNING:
Never fill fuel tank indoors, or
with the engine running, or while the engine
is hot. Do not smoke while filling tank.
HOW
TO STOP
YOUR
VAC
SYSTEM
To stop engine, move the throttle control lever to the
OFF position.
Disconnect spark plug wire from plug to prevent
accidental starting while equipment
is unattended or
is being worked on.
,_
CAUTION:
_-he muffler and adjacent
areas are hot!
HOW TO START
YOUR VAC SYSTEM
A
WARNING:
Never start or run the
engine without all covers being properly
attached to the blower housing and cart.
Check oil and gas in Vac engine.
Attach spark plug wire to spark plug.
Move choke lever on engine to CHOKE position.
(A warm engine may not require choking.)
Move throttle control lever on engine to FAST position.
Grasp starter handle and pull rope out slowly until
engine reaches start of compression cycle (rope will
pull slightly harder at this point). Let the rope rewind
slowly.
Pull rope with a rapid, continuous, full arm stroke.
Keep a firm grip on starter handle. Let rope rewind
slowly. Do not let starter handle snap back against
starter.
Repeat instructions
in two preceding paragraphs until
engine fires. When engine starts, move choke control
gradually to RUN position.
HOW TO USE YOUR VAC SYSTEM
A
CAUTION:
Vehicle braking and stability
may be affected with the addition of an
accessory or an attachment. Be aware of
changing conditions on slopes.
Inspect the Vac to make sure all covers (rear door,
hard top boot, elbow, hose adapter (nozzle), hose and
deck adapter are properly attached.
Check tires for proper inflation (12 - 14 Ibs).
Check oil and gas in Vac engine.
Begin operation at low speed, adjusting forward speed
to match grass height and/or moisture condition to
prevent clogging.
Do not attempt to vacuum up any material other than
vegetation found in a normal yard, such as light
branches, leaves, twigs, etc.
&
WARNING:
Should your Vac System
become clogged, shut off tractor and Vac
engines. Before attempting
to unclog,
remove wire from spark plug to prevent
accidental
starting.
To empty cart, shut off tractor engine and set brake.
Shut off Vac engine.
Remove rear door from cart.
Release latch lock lever on tongue and tip cart back.
See figure 35.
,_
CAUTION:
To avoid possible injury, be
sure that no one is near the cart before
releasing the latch lock lever.
Lift rear of harcl'.top and secure it in the upper raised
position with right and left prop rods.
Using a rake or suitable tool, pull grass clippings and/
or leaves out of cart.
After cart is emptied, close hard top, tip cart for-
ward and secure it to the tongue. Reattach rear
door and hardtop boot.
FIGURE 35
20

Advertisement

loading