General Instructions; Care Of Glass And Plated Parts - Napoleon Torch GSST8N Installation And Operation Instructions Manual

Installation and operating instructions manual (27 pages)

Table of Contents

THIS GAS APPLIANCE SHOULD BE INSTALLED AND SERVICED BY A QUALIFIED INSTALLER to conform with local

codes. Installation practices vary from region to region and it is important to know the speciﬁ cs that apply to your area,

for example: in Massachusetts State:

• The appliance off valve must be a "T" handle gas cock.

• The ﬂ exible connector must not be longer than 36 inches.

• WARNING: This product must be installed by a licensed plumber or gas ﬁ tter when installed within the commonwealth of

Massachusetts.

In absence of local codes, install to the current CAN/CGA -B149

Installation Code in Canada or to the National Fuel Gas Code, ANSI

Z223.1, and NFPA 54 in the United States.

The appliance and its individual shutoff valve must be disconnected from

the gas supply piping system during any pressure testing of that system

at test pressures in excess of 1/2 psig (3.5 kPa). The appliance must

be isolated from the gas supply piping system by closing its individual

manual shutoff valve during any pressure testing of the gas supply piping

system at test pressures equal to or less than 1/2 psig (3.5 kPa).

FOR YOUR SATISFACTION, THIS APPLIANCE HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION AND QUALITY!

Altitude

Maximum Input

Minimum Inlet Gas Supply Pressure

Maximum Inlet Gas Supply Pressure

Manifold Pressure Under Flow Conditions

* When the appliance is installed at elevations above 4,500ft, and in the absence of speciﬁ c recommendations from

the local authority having jurisdiction, the certiﬁ ed high altitude input rating shall be reduced at the rate of 4% for

each additional 1,000ft.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible

for use with other gases, unless a certiﬁ ed kit is used.

Expansion / contraction noises during heating up and cooling down cycles are normal and are to be expected.

Purge all gas lines with the glass door of the appliance removed. Assure that a continuous gas ﬂ ow is at the burner

before replacing the door.

Objects placed in front of the appliance must be kept a minimum of 48" from the front face of the unit.

Use only authorized accessories designed for and listed with the model.

The glass is 3/16" tempered glass, available from your

authorized dealer. Clean the glass after the ﬁ rst 10 hours of

operation with a recommended gas appliance glass cleaner.

Thereafter clean as required. DO NOT CLEAN GLASS WHEN

HOT! Do not use abrasive cleaners to clean plated parts.

Buff lightly with a clean dry cloth. If the glass is not kept clean

permanent discolouration and / or blemishes may result.

W415-0689 / 06.25.08