NAPCO GEMINI GEM-P400 User Manual page 12

Hide thumbs Also See for GEMINI GEM-P400:
Table of Contents

Advertisement


Keypad Beeps or
Zone light
ON
Flashes
2 Beeps
3
Wireless Receiver
Trouble
2 Beeps
4
Wireless Receiver Jam A problem has been detected with a wireless receiver.
3 Beeps
1-4
Wireless Transmitter
Low Battery
4 Beeps
1-4
Wireless Transmitter
Supervisory Failure
7 Beeps
1-4
Zone Trouble
12
Oi230a
page 12
System Trouble
Condition
A problem has been detected with the wireless receiver.
Call installing company for service.
Call installing company for service.
The battery in a wireless transmitter is low and should be replaced. This transmitter is
on the zone corresponding to the number of the lit zone light. The replacement battery
for the GEM-Trans2 door/window transmitter, GEM-PIR motion detector and GEM-GB
glass break detector is the Duracell DL123A 3 volt lithium. (2 required for the GEM-PIR
and GEM-GB.) The GEM-DT Dual Technology Sensor requires 4 C cell alkaline batter-
ies.
Warning: Replace batteries only with the same type as specified above. Use of another
battery may present a risk of fire or explosion. Do not recharge or disassemble battery,
or dispose of in fire.
A problem has been detected with a wireless transmitter.
Call installing company for service
Call installing company for service.

System Troubles
Action
Tuesday, September 16, 1997 08:26


Advertisement

Table of Contents
loading

Table of Contents