Chapter2 Installation Of The Scanner; Installing The Scanner; Connecting The Scanner To Your Personal Computer - Fujitsu fi-5530C2 Getting Started Manual

Chapter2

2.1 Installing the Scanner

1. Place the scanner at its installation site.
For details on the scanner's dimensions and
required installation space, refer to section 7.2
"Installation Specifications" of "fi-5530C2 Oper-
ator's Guide" on the Setup CD-ROM.
2. Attach the ADF paper chute.
Hold the ADF paper chute and insert its tabs into
the corresponding slots in the scanner as shown in
the figure below.
The Side guides of the ADF paper chute have to
face up.
ADF paper chute
Side guide
3. Connect the AC adapter.
Use only the AC adapter provided by the
ATTENTION
manufacturer.
1) Connect the AC cable to the AC adapter.
INSTALLATION OF THE SCANNER
Tab
fi-5530C2 Image Scanner Getting Started
2) Connect the AC adapter connector to the scan-
ner's DC inlet.
3) Plug the AC cable into the outlet.
The Function Number Display and the LED
HINT
may flash for an instant when plugging the
AC cable into the outlet.
2.2 Connecting the Scanner to
Your Personal Computer
Connect either with the USB interface cable or the SCSI
interface cable.
This scanner is provided with two inter-
ATTENTION
faces: Ultra SCSI and USB 2.0 /1.1. Con-
nect only one of the USB or SCSI interface
cable.
■ Connecting with the USB
Interface Cable
1. Connect the USB interface cable to the USB
interface connector.
3