Troubleshooting Tips - Hotpoint RGB790WEKWW - Gas Range Owner's Manual

Before you call for service...
Troubleshooting tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Topburners do not light
or do not bum evenly
Possible Causes What To Do
Plug on rmlge is not completely
inserted in the electrical outlet.
Burner hole or slits on the side
of the burner may be clogged.
• Make
sure electrical plug is plugged into a live, properly
grounded buffet.
• Ren/ove tile burne_ (on models with standard twin
bm'ne_) or bm'ner heads and caps (on models with
sealed burne_) and clean them with a sewing needle
or twist-fie. Make sure you do not enlarge tile holes.
On sealed burner models, check and clean tile electrode
area for
b/u'iled-oll
t0od
or grease.
hnproper bun_er assembly. • Make sure the burner parts m'e installed correctk.
See the
Care and cleaning of the range section.
Burner flames very hnproper air to gas ratio. • If range is connected to 12 gas, cm]tnct the l/e_sou
large oryellow who installed your range or made the couve_iou.
Surface burners light
but oven does not
The oven gas shut-off valve
may have accidentally been
moved durhlg clemlh_g or
movhlg.
• To check tile oven gas shut-off valve on sealed burner
models, remove tile storage drawer or kick panel (see
tile Care and cleaning of the range section) and look fin.
tile gas shut-off lever at tile back of tile range.
Lever is
shownclosed
PULL TOOPEN.
Sealed burner models
• To check
tile oven gas shut-off valve on standard twin
bm'ner models, raise tile cooktop and look fin" tile gas
sh ut-off lever at tile extreme right rear corne_: Follow
tile directions in box
A or B
that match yore" regulator
_])e.
Lever is shownclosed. A
POLk TOO, P EN._
Standardtwin burnermodels Standardtwin burnermodels
Control signals alter
You forgot to enter a bake • Touch the
BAKE
pad :rod desired temperattu'e or
entering cooking time
temperature or clemlhlg time.
the SELFCLEANpad
and desired clean time.
or start time
Plug on range is not completely • Make sure electrical l/lug, is l/lugged,, into a live,
do not work inserted in the electrical outlet, prol/erl } grotmded buffet.
AblownfUse orha yourthe circuith°mebreakermay be • Replace the fl/se or reset the circuit breakel:
tripped.
Oven conlrols improperly set. • See the Using the clock and timer section.
44