Ford SUPER DUTY F SERIES Incomplete Vehicle Manual page 25

87.0 78.0
[3.42] [3.07]
78.0
C L
OF BRACKET [3.07]
HOLES (12 PLACES)
C L OF FILL PIPE ASY.
AND BRACKET
PROTECTIVE SLEEVES ARE
REQUIRED ON BOTH FILL AND
VENT HOSE WHERE PASSIN G
OVER FRAME.
STEEL ELBOW
DO NOT TRIM
CAP
1/4 TURN - GASOLINE - LEV II
SCREW IN - DIESEL
SCREWS (3 REQ'D)
TORQUE 1.7-2.8
NEWTON METERS
[15-25 IN. LB.]
P
THIS HOSE IS PREFORMED; INSTALL SHORT EN D
TO THE METAL NECK AND CAP ASSEMBLY;
TRIM THE LONG END AS REQUIRED.
(CA) BACK OF CAB TO CENTERLINE OF REAR AXLE
Regular Cab
Super Cab
Crew Cab
MIN
A
MAX
MIN
C
MAX
MIN
D
MAX
FIGURE B – SUPER DUTY F-SERIES WIDE FRAME PICKUP BOX DELETE FUEL FILLER PIPE INSTALLATION
F-SERIES
(March, 2005)
U
48.0
[1.89]
48.0
[1.89]
48.0
[1.89]
48.0
[1.89]
48.0
[1.89]
48.0
[1.89]
81.0 81.0
[3.19] [3.19]
U
VIEW P
TO BACK
FRONT OF
OF CAB
VEHICLE
A
RECIRCULATION
STEEL TUBE
56 INCH CA
WHEELBASE
3480mm [137.0]
4013mm [158.0]
4380mm [172.4]
620mm [24.4]
923mm [36.7]
540mm [21.25]
743mm [29.25]
267mm [10.5]
343mm [13.5]
SUB
48.0
[1.89]
105.7
[4.16]
67.5
[2.66]
POINT Z
REFER TO CALIFORNIA
FUEL VAPOR RECOVERY
REQUIREMENT.
90º FITTING - CONNECT TO
QUICK CONNECTION ON VAPOR LINE
OUTBOARD SURFAC E
OF FRAME RAIL
C
FILL HOSE
STEEL ELBOW
DO NOT TRIM
RECIRCULATION
HOSE
D
RECIRCULATION
HOSE CLAMP
TOP OF FRAME RAIL
C
AT L OF FILL PIPE
INSTALL GROUND WIRE TO
SOUND METAL ON THE FRAME.
NOTES:
TORQUE ALL WORM GEAR DRIVEN HOSE CLAMPS
TO 2.8 - 3.9 NEWTON METERS [25-35 IN. LB.]
[ ] DIMENSIONS ARE INCHES
* NOT SUPPLIED BY FORD MOTOR COMPANY
Remove and discard the Ford installed fuel fill system components
(provided for shipping purposes only) except save and reuse the
metal neck and cap assembly.
Use the new hoses, pipes, scuff guards, tie wraps, and clamps
provided in the dunnage kit.
The completed fuel fill system must provide a 4 degree minimum,
continuous, downward slope to the fuel tank. Additional support may
be required to prevent hose sagging which could cause spray or
spitback during normal fueling operations.
Do not extend the fuel fill system outboard of the second unit body.
23
3/16 INCH
BLIND RIVET *
(12 REQ' D)
616.0
[2.42]
75
SCREWS (3 REQ'D)
TORQUE 1.7-2.8
NEWTON METERS
[15-25 IN. LB.]
SECTION U
#4 CROSSMEMBER
TOP OF FRAME RAIL
STATEMENTS OF CONFORMITY