1. Reconnect the top display-cable connector to the top flex-cable connector.
2. Reconnect the bottom flex-cable connector to the inverter connector.
3. Replace the display panel inside the display back cover.
4. Tighten the captive screw that attaches the display-panel ground wire to the display back cover.
5. Replace the eight M2 x 3-mm screws (four on each side) around the display panel.
6. Replace the display bezel (see
Display Latch
Removing the Display Latch
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
1. Follow the instructions in
Before Working Inside Your
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Slide the latch to the right and gently lift.
5. Remove the spring that attaches the latch to the display panel.
1
spring
Replacing the Display Latch
1. Replace the spring that attaches the latch to the display panel.
2. Align the latch with the display panel and slide the latch to the left to secure it into place.
Back to Contents Page
Replacing the Display
Bezel).
Computer.
Removing the Display
Assembly).
Removing the Display
Bezel).
2
display latch