Enterasys RoamAbout RBT-8110 Installation Manual page 32

Wireless Switch Configuration Tasks
6. Enable the MSS DNS client:
RBT-8110# set ip dns server enable
7. Enable the auto‐config option:
RBT-8110# set auto-config enable
8. Save the configuration changes:
RBT-8110# save config
9. Reset the switch by using one of the following methods:
•
•
Example 4: Deployment Site Has DHCP But Local DNS Domain Differs From
Corporate DNS Domain
The deployment site in this example has a DHCP server, so the switch's DHCP client is enabled.
Static IP address and default router (gateway) information are not required. The site also has a
local DNS server. However, the local DNS domain name is different from the corporate DNS
domain name where the RASM server is located. The static DNS configuration on the switch
overrides the DNS configuration from the DHCP server.
1. Configure a VLAN:
RBT-8110# set vlan 1 port 1
2. Enable the DHCP client on VLAN 1:
RBT-8110# set interface 1 ip dhcp-client enable
3. Configure the default DNS domain name:
RBT-8110# set ip dns domain customer.com
4. Configure DNS server information:
RBT-8110# set ip dns server 192.168.11.2
5. Enable the MSS DNS client:
RBT-8110# set ip dns server enable
6. Enable the auto‐config option:
RBT-8110# set auto-config enable
7. Save the configuration changes:
RBT-8110# save config
8. Reset the switch by using one of the following methods:
•
•
3-8 Configuration
Enter the following command:
RBT-8110# reset system
Turn the power off to the switch, and then turn the power back on.
Enter the following command:
RBT-8110# reset system
Turn the power off to the switch, and then turn the power back on.