Testing The System (Using The 5 Test Key) - First Alert FA120C User Manual

TESTING THE SYSTEM
The TEST key puts your system into Test mode, which allows each pro-
Using the
tection point to be checked for proper operation.
ÊÊ5ÊÊ TEST Key
1. Disarm the system and close all protected windows, doors, etc. The
NO ALARM REPORTS
WILL BE SENT TO THE
2. Enter your security code and press the TEST key.
CENTRAL MONITORING
3. The keypad will sound a single beep every 40 seconds as a reminder
STATION while the
system is in Test mode.
Each time a protection zone is faulted, the external siren or bell should
sound for one second and then turn off, while the keypad sounds 3 beeps.
If this does not happen, call for service immediately.
4. Open and close each protected door and window in turn and listen for
5. Walk in front of any interior motion detectors (if used) and listen for the
Note: Wireless PIR (Passive Infrared) units will send signals out only if
TO BE CONDUCTED WEEKLY
keypad's READY message should be displayed and the READY
indicator (if present) should be lit.
that the system is in the test mode.
the required sounds The identification of each faulted protection point
should appear on the display.
required sound as movement is detected. The identification of the
detector should appear on the display when it is activated.
they have been inactive for 3 minutes.
Ð 2 4 Ð