SUMMARY OF AUDIBLE/VISUAL NOTIFICATIONS
S O U N D
C A U S E
LOUD, INTERRUPTED
FIRE ALARM
Keypad & External
LOUD, CONTINUOUS
BURGLARY/AUDIBLE
Keypad & External
EMERGENCY ALARM
ONE SHORT BEEP
a. SYSTEM DISARM
(not repeated)
b. SYSTEM ARMING ATTEMPT
Keypad only
WITH AN OPEN ZONE
c. BYPASS VERIFY
ONE SHORT BEEP
SYSTEM IS IN TEST MODE
(once every 40 seconds)
Keypad only
ONE BEEP every 40 sec.
a. LOW BATTERY AT XMTR
Keypad only
b. TROUBLE
TWO SHORT BEEPS
ARM AWAY OR MAXIMUM
Keypad only
THREE SHORT BEEPS
a. ARM STAY OR INSTANT
Keypad only
b. ZONE OPENED WHILE SYS-
TEM IS IN CHIME MODE
c. ZONE OPENED WHILE SYS-
TEM IS IN TEST MODE
RAPID BEEPING
MEMORY OF ALARM
Keypad only
SLOW BEEPING
ENTRY DELAY WARNING
Keypad only
If bell is used as external sounder, fire alarm is pulsed ring; burglary/audible emergency is steady ring.
N o t e s : ¥ BAT displayed (with no beeping or zone number) indicates system main battery is weak (see page 27).
¥ Also see Power Failure, and Other Displays under TROUBLE CONDITIONS on page 27.
DISPLAY
FIRE and ALARM are displayed; protection zone in alarm is displayed.
ALARM is displayed; protection zone in alarm is also displayed.
a. Only READY is displayed. Green READY indicator (if present) is lit.
b. NOT READY is displayed, open protection zone number is displayed.
Green READY indicator (if present) is not lit.
c. The bypassed protection zone numbers are displayed. (One beep for each number
displayed.) BYPASS also displayed.
Opened Zone identifications will appear.
a. BAT displayed with ID number of transmitter.
b. CHECK displayed. Troubled protection zone is displayed.
AWAY and (if MAXIMUM) INSTANT are displayed.
a. STAY and (if INSTANT) INSTANT are displayed. Red ARMED indicator is lit.
b. CHIME displayed. Pressing / READY key will display opened zone.
c. Open protection zone number is displayed.
FIRE and/or ALARM is displayed; zone in alarm is displayed.
None during delay; Exceeding the delay time without disarming causes alarm.
Ð 3 4 Ð
Need help?
Do you have a question about the FA120C and is the answer not in the manual?
Questions and answers