Check The Cables; How To Set The Skid Height; How To Set The Length Of The Cables - Craftsman 536.881121 Owner's Manual

Check The Cables
1, Check the traction drive cable and
the auger drive cable. If the bottom
of the cables have become discon-
nected, reinstall the cable springs.
Make sure the long spring is at-
tached to the traction drive and the
short spring is attached to the au-
ger drive. See Figure 12.
TractionAUger Drive Cable
Drive Cable Short "_
/ Spring ,_
= iJ
_i_ LongSpring \'\
C
Figure 12
2. If the top of the cables have be-
come disconnected from the drive
levers, attach the cables to the "Z"
fitting. See Figure 13.
"Z" Fitting Drive Lever
\
\
Cable Figure 13
How To Set The Skid Height
The snow thrower is equipped with
height adjustable skids mounted on
the outside of the auger housing. See
Figure 14. To adjust the height of the
skids, see "How To Adjust The Height
Of The Skids" in the Maintenance
section.
Adjustable Skids Figure 14
How To Set
The Length Of The Cables
The cables were adjusted at the factory
and no adjustments should be neces-
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust-
ment is necessary, see "How To Check
And Adjust The Cables" in the Service
And Adjustment section.
F_)01162J 11