Craftsman Nextec 320.61199 Operator's Manual page 11

• Keep the cord and charger from heat to prevent damage to housing or
internal parts.
• Do not allow gasoline, oils, petroleum-based products, etc. to come in
contact with plastic parts. These materials contain chemicals that can
damage, weaken, or destroy plastic.
• An extension cord should not be used unless absolutely necessary. Use of
an improper extension cord could result in a risk of fire and electric shock. If
an extension cord must be used, make sure that:
The pins on plug of extension cord are the same number, size and shape as
those of the plug on charger.
The cord is properly wired and in good electrical condition
The size is large enough for AC ampere rating of charger as specified below:
The Cord Length (Feet)
25' 50' 100'
Cord Size(AWG) 16 16 16
NOTE: AWG = American Wire Gauge
• Do not operate the charger with a damaged cord or plug, as this could
cause shorting and electric shock. If damaged, have the charger repaired or
replaced by an authorized service technician at a Sears Service Center.
Do not operate the charger if it has received a sharp blow, been dropped,
or has otherwise been damaged in any way. Take it to an authorized service
technician at a Sears Service Center for an electrical check to determine if
the charger is in good working order.
• Do not disassemble the charger. Take it to an authorized service technician
at a Sears Service Center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
• Unplug the charger from the electrical outlet before attempting any
maintenance or cleaning to reduce the risk of electric shock.
Disconnect charger from the power supply when not in use. This will reduce
the risk of electric shock or damage to the charger if metal items should fall
into the opening. It will also help prevent damage to the charger during a
power surge.
• Risk of electric shock. Do not touch the uninsulated portion of output
connector or uninsulated battery terminal.
Save these instructions. Refer to them frequently and use them to instruct
others who may use this tool. If you lend this tool to someone else, also lend
these instructions to them to prevent misuse of the product and
possible injury.
61199 Manual_Revised_09 0310 Page 11