basic operation
FINISHING
CURVED
EDGES ON THE
ABRASIVE
BELT
CURVED EDGES
Finish
outside
curves
on the abrasive
belt
and
inside
curves
on the idler pulley.
FINiSHiNG
SMALL
END
SURFACES
AND
CURVED
EDGES
ON THE ABRASIVE
DISC
Move the work across the "Down Side" of the face of
the abrasive disc. For accuracy, usea miter gauge.
NOTE:
Use a combination
square to square the miter
gauge to the face of the disc. If it is not square, pull out
the index pin, loosen the miter gauge knob and move the
miter gauge s]ightly
until it is square. Without moving
the miter gauge,tighten the knob securely.
SQUARE
MITER
GAUGE
Applying
the workpiece to the "Up Side" could cause it
to fly up (kickback) which could be hazardous.
The table may be tilted for beveled
work.
2t