Check Spark Arrester (If Equipped); Thread Locking Adhesives - Exmark LAZER Z D-SERIES Operator's Manual

Maintenance
Figure 16
1. Oil dipstick
4. Reinstall all drain plugs and hoses and tighten
drain cock.
5. Fill radiator with a 50/50 mix of water and
Dex-Cool© coolant as specified in the Check
Engine Coolant Level Section, allowing some
room (approximately 1/2 inch (12.7 mm)) for
expansion. Add 50/50 coolant mix to overflow
bottle on the left side of the engine as required
to bring the level up to the indicator line on the
bottle.
WARNING
Engine compartment contains open belt
drives, fans, and other rotating components
that can cause injury. Fingers, hands, loose
clothing, or jewelry can get caught by the
rotating fan and drive shaft.
• Do Not operate machine without the
covers in place.
• Keep fingers, hands, and clothing clear of
rotating components.
• Shut off engine, wait for moving parts to
stop, engage parking brake and remove
key, before performing maintenance.
6. With the cap off the radiator, tilt hood closed and
put the seat down. Start the engine as stated in
the Operating Instructions Section. Return the
seat up and hood forward to the open position.
7. Operate engine until the engine thermostat opens
and coolant is circulating through the radiator
2. Drain cock
core. As air is purged from the engine block and
the coolant level drops, add additional coolant to
the radiator.
8. When the radiator is completely full and no
additional coolant can be added, continue running
and install the radiator cap. Make sure that the
cap is completely seated by pressing down firmly
while turning until the cap stops. Once the cap is
installed, the engine may be stopped.
Check Spark Arrester
(if equipped)
Service Interval: Every 50 hours
WARNING
Hot exhaust system components may ignite fuel
vapors even after the engine is stopped. Hot
particles exhausted during engine operation may
ignite flammable materials. Fire may result in
personal injury or property damage.
Do Not refuel or run engine unless spark arrester
is installed.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Wait for muffler to cool.
3. If any breaks in the screen or welds are observed,
replace arrester.
4. If plugging of the screen is observed, remove
arrester and shake loose particles out of the
arrester and clean screen with a wire brush (soak
in solvent if necessary). Reinstall arrester on
exhaust outlet.

Thread Locking Adhesives

Thread locking adhesives such as "Loctite 242"
or "Fel-Pro, Pro-Lock Nut Type" are used on the
following fasteners:
• Pump drive sheave set screws.
• Square head setscrews on Hydro pump control
arms.
• Sheave retaining bolt in the end of engine
crankshaft.
• Caster wheel spacer nuts.
38