Table of Contents
Advertisement
ESR-9710 Wireless N Gigabit Router
1.4 Wireless SOHO Router Description
Rear Panel
Antenna
Connector
SMA
SMA
SMA
SMA
WAN Port
Front Panel
Power LED
Step
Label
1
LAN Ports (1 – 4)
2
WAN Port
3
DC Connector
4
Antenna Connector
Connection / Activity
LED
WAN LED
WLAN LED
Power LED
Reset Button
WPS
Antenna
Connector
SMA
SMA
SMA
SMA
WAN
WAN
WAN
WAN
LAN: 4*RJ45
LAN: 4*RJ45
LAN: 4*RJ45
LAN: 4*RJ45
10/100/1000M
10/100/1000M
10/100/1000M
10/100/1000M
LAN Ports (1-4)
WPS Button
WLAN LED
Use an Ethernet cable to connect each port to a computer
on your Local Area Network (LAN).
Use an Ethernet cable to connect this port to your WAN
router.
Use the power cable and connect the adapter to the power
socket on the wall, and the DC inlet into the DC connector.
Connect the three antennas to the SMA connectors.
This LED will light up once an Ethernet cable is connected
to one of the LAN ports.
This LED will light up once an Ethernet cable is connected
to WAN (Internet) port.
This LED will light up once the RF (wireless LAN) feature is
enabled
This LED will light up once the power cable is connected to
the DC connector.
Use this button to reset the device. You can restore the
device back to its factory default settings by holding down
on this button for 5 seconds.
WPS (Wireless Push Button) is used for WiFi Protected
Setup. By pressing this button, the security settings of the
Antenna
Connector
SMA
SMA
SMA
SMA
DC JACK
DC JACK
DC JACK
DC JACK
DC Connector
Reset Button
LAN 1- 4 LED
Description
Version 1.0
WAN LED
7
Advertisement
Table of Contents
